Gypsum tiles must be laid properly, as not just the aesthetic look of decorative facing, but in addition the service life of the

material will depend on the engineering of work. The product is also universal, and it may be connected to plaster, concrete,

brick or gypsum board sheets, provided the surface of the foundation is and has no flaws.

If the flaws of this base are significant, it ought to be thoroughly treated with primer, then a cement mortar is made, which

matches all the cracks. Then the surface ought to be primed and dried. Primer therapy is essential to improve the bond between the

tile and the wall. In this case, its composition should decide on a special, comprising elements which block the look of fungus

and mold.

In today’s interior of the rooms most often used gypsum tiles, imitating natural brick or stone. To execute cosmetic finishing

yourself, it is necessary firstly to pick a strategy of tile placement and prepare a remedy. It is necessary to pay attention to

the reverse side of this material. When its surface includes an embossed surface, then the adhesive ought to be placed with an

trowel, and if it is even, then with a notched one.

The technology of the work is as follows:

* A thin layer of glue mortar is applied to the pre-prepared wall. It’s spread over the foundation so it is possible to put 4-5

tiles. Decorative cladding can be placed either on plasterboard, and on putty.

* Glue the back side of these tiles with glue.

* Plaster elements are pressed against the wall and their place is corrected. To align with the seams, it is advised to use

spacers.

* Finishing is carried out in rows, all which ought to be changed by half a tile. Facing is carried out to the corners of the

space, and then immediately eliminate any residual mortar at the joints.

Drying the walls requires no more than a day and demands a continuous humidity and temperature within the room. The final point in

the laying of gypsum tiles is the decoration. To try it, the joints between these components are filled with a unique solution,

the color of which suits the brick.

Cosmetic fake of brickwork on the walls is carried out in the following manners:

* Cutting on the darkened surface of the seams of masonry using a bolt cutter along with your hands;

* laying of tiles under the brick:

* mimicking the structure and colour of the side surface of one brick;

* Imitating a fragment of brickwork of many bricks.

The very best method to decorate”beneath the brick” is the one which allows you to create a practical coating together with the

maximum look of its similarity to organic masonry. All 3 approaches to perform this sort of finishing works fulfill the demands,

however, the cutting edge of joints using a bolt is labor-intensive and the formation of considerable amounts of dust, so let us

consider more typical ways.

The old finish is removed from the walls, and also the outside, if needed, is leveled to eliminate the need to paste plaster on a

thick layer of glue.

Combining these cladding with other kinds of interior finishes may be both systematic and done with no clear consequences,

chaotically, together with fake of signs of aging.

With the support of cosmetic gypsum tiles it’s possible to imitate a lot of textures.

A lot of textures can be imitated with the help of cosmetic gypsum tiles.

The wall where it is to be installed should possess the following characteristics:

* Hardness and strength of the surface;

* The lack of irregular locations and sharp differences;

masterfasada.ru * not any deformations.

Cosmetic tiles in the interior of the kitchen

Walls are made from a variety of substances, so let’s break down the individual rules of installation.

When working with concrete, there’ll not be any big problems. It’s simply essential to take into consideration the porosity of the

material. Concrete, that has almost no pronounced pores, should be treated with a great primer.

Mounting gypsum tiles concrete

Before starting work on the setup of gypsum tiles onto the walls, it’s worth assessing the strength of this surface. After the

plaster does not fall off the wall and in precisely the identical time holds well, it is possible to simply paint it with primer.

Mount the tiles onto the painted concrete shouldn’t. The surface should be scratched, ensuring to misfire, and it should be

grouted and covered with a layer of plaster.